8/17/2023 0 Comments Multisim 7 segment display imputCan drive a common cathode 7-Segment display directly.This pin powers the IC, typically +5V is used. This input pin when made high (+5V) will reset the count to 0. This is an output pin which will be rarely used when division is required. The ground pin should be connected to ground of circuit These are the decoded output pins which should connected to 7-Segment display. This pin will be only if more than one CD4026 IC is used (cascaded) This is the carry over output pin it produces a pulse after counting till 9. This is an output which always stays high, this pin will be only if more than one CD4026 IC is used (cascaded) This pin is connect to +5V (high) to enable the output pins (Out A to Out G) The counting happens when this clock pulse goes high, this pin is normally connected to 555 timer or other uC to produce a pulseĬonnected to the Ground (low) of the circuit, to enable clock pin
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |